IS200EDCFG1A GE Controller Exciter DC Feedback Board

Product Description

Part number IS200EDCFG1A is part of the EX2100 Excitation Controller Series. This model is an exciter direct current feedback board, which measures field voltage and field current at the SCR bridge. To properly use this model it is necessary to connect it to the EISB board when done so two fiber-optic cables are used for one signal each. The two fiber-optic cables that can be used are plastic fiber, the plastic fiber cable is used for distances up to ten meters; and a hard-clad silica fiber cable, this cable is used for distances up to ninety meters. Please note that the minimum bending radius of these cables is each one and a half inches. 

The field voltage feedback of the IS200EDCFG1A will always be measured across the negative terminal of the bridge device and across the positive terminal of the shunt. When the voltages have been scaled alongside the jumpered resisters the signals will proceed to be input to a different amplifier, this amplifier controls the VCO.

There are two manuals that can be used with the IS200EDCFG1A model, one of them is the general GEH-6632 EX2100 Excitation Control User’s Guide and the other is the GEI-100464 Exciter DC Feedback Board manual.

IS200EDCFG1A