48PT2-1007 FLAME SCANNERS FIREYE

Description

Overview

Essential details：48PT2-1007 FLAME SCANNERS FIREYE

The 48PT2 scanner comes with cables rated for Tray Cable – Exposed Run (TC-ER) and complies with the crush and impact requirements of the standard for metal clad cable, UL 1569.
48PT1 (Obsolete)
The 48PT1 lead sulfide infrared scanner contains a high impedance detector and is designed to be used only on P-Series controls.
48PT2
The 48PT2 lead sulfide infrared scanner contains a low impedance detector and is designed to detect low flicker frequency IR signals from gas and oil flames. It is designed for use on D-Series, FlameMonitor, FlameWorx, MicroM and Burnerlogix controls.
48PT2-CEX
The 48PT2-CEX is a 48PT2 mounted in a ATEX compliant housing for environments requiring the rating of Exd IIC T6 ATEX hazardous location.
69ND1
The 69ND1 flame rod is made of high temperature resistant metal and can be used only to detect gas flames. The rods come in 12, 18 and 24 inch lengths

48PT2-1007

48PT1 and 48PT2, 48PT2-CEX Infrared Scanners and 69ND1 Flame Rods
The viewing area of the scanner must be kept clean. Even a small amount of contamination will reduce the flame signal reaching the detector by a measurable amount. Wipe the viewing area routinely using a soft cloth dampened with concentrated detergent.
Type 48PT1 scanner includes a replaceable #4-128-1 cell
Type 48PT2, 48PT2-CEX scanner includes a replaceable #4-263-1 Firetron cell.
Type 69ND1 Flame Rod. Rods should be routinely replaced as they oxidize.
Flame Signal Strength. Routine observation of the flame signal strength or as read on the display of the FLAME-MONITOR will forewarn of any deterioration in the capability of the flame detector or its application.
Periodic Safety Check. It is recommended that a procedure be established to test, at least once a month, the complete flame safeguard system. This test should verify the proper operation of all limit switches and safety interlocks as well as flame failure protection and fuel safety shutoff valve tightness.
Rotation. It is recommended that control and scanner units purchased as spares be installed periodically.
Contacts. There are no accessible contacts in the Fireye burner programming controls. Where contacts are used, their design assures long trouble-free life when the load circuits are maintained within the published load ratings.
Humidity. In areas of high humidity, the control chassis should be removed and placed in a dry atmosphere when the system is expected to be out of service for an extended period.
For scanner installation and wiring instructions, see the appropriate FIREYE technical bulletin for each control.

lf you need to inquire or purchase ,please send the product models to my email or call medirectly .