IC687BEM742 FIP Bus Controller

Description

Overview

Essential details：IC687BEM742 FIP Bus Controller

才

RS-485 serial port attaches to PC for easy in-system firmware upgrade (no PROMS to change)

Pushbutton for resetting Bus Controller and enabling Bus Controller to accept upgrades

FIP bus faults managed by PLC Alarm processor Function

Six status LEDs

Software configuration (no DIP switches or jumpers to set)

Installation should not be attempted without referring to the applicable Programmable Controller Installation Manual and the FIP Bus Controller User’s Manual.

Be sure that rack is powered down.

Position the FIP Bus Controller at its intended slot location in the VME Integrator rack.

Slide the FIP Bus Controller into the card guide until it is aligned with the connector on the rack backplane.

Push the module into the connector until it clicks onto the rack rails. Be sure that the board has seated properly in the connector. Tighten screws to hold module in place.

Bus connections to the connectors on the front of the module can now be made.

IC687BEM742

lf you need to inquire or purchase ,please send the product models to my email or call medirectly .

IC687BEM742 FIP Bus Controller

This FIP Bus Controller (FBC) is a two channel bus controller that occupies a single half-slot in an IC697 PLC VME Integrator rack. The FBC is configured with MS-DOS or Windows based programming software. I/O devices on the FIP bus are scanned asynchronously by the bus controller and I/O data is transferred to the CPU once per scan. Up to 31 Bus Controllers, of any kind, can be included in an IC697 PLC system. Of the 31 Bus Controllers, a maximum of four can be FIP Bus Controllers.
A FIP bus may serve:

Remote Drops, IC693 I/O racks that are interfaced to the bus through Remote I/O Scanner Modules.
Each remote drop can include any mix of discrete and analog I/O modules.

Field Control Stations, Field Control I/O modules that are interfaced to the bus via a FIP Bus Interface Unit (BIU).

A FIP Bus Controller module can be installed in any I/O slot in the CPU rack (VME Integrator rack– IC697CHS782 or IC697CHS783) of an IC697 PLC system. The following figure shows a typical installation with a FIP Bus Controller connected to an IC693 Remote I/O Scanner which allows IC693 I/O modules to be on the FIP Bus. The IC693 Remote I/O Scanner and the modules it serves are referred to as a FIP I/O Nest. For detailed information on the IC693 Remote I/O Scanner, refer to the Remote I/O Scanner User’s Manual.