Sale!

IS200WETBH1BAA Mark VI printed circuit board

The IS200WETBH1BAA  is a component created by GE for use within the Mark VI system.  The Mark VI is part of the Speedtronic series, which is a gas/steam turbine management series developed by General Electric between the 1960s and the 1990s that focused on improving the running efficiency of their related turbine systems through the use of reliable management.  The MKVI is built with both general purpose I/Os as well as application specific I/Os. These control and monitor for issues like flame detection, vibration, shaft voltage build-up, and proper synchronization.

Add to quote
Categories: ,

Description

Overview

Essential details：IS200WETBH1BAA Mark VI printed circuit board

Product Description

The IS200WETBH1BAA  is a component created by GE for use within the Mark VI system.  The Mark VI is part of the Speedtronic series, which is a gas/steam turbine management series developed by General Electric between the 1960s and the 1990s that focused on improving the running efficiency of their related turbine systems through the use of reliable management.  The MKVI is built with both general purpose I/Os as well as application specific I/Os. These control and monitor for issues like flame detection, vibration, shaft voltage build-up, and proper synchronization.

The  IS200WETBH1BAA is a component-dense board.  The edge of this board has an exposed copper strip factory drilled at regular intervals.  The majority of the board’s 65+ plugs and connectors are placed along the board edges. These include plugs with two positions up to twenty positions.   Female jacks range from four positions to twelve positions. The interior board also has three vertical male connectors; P1 is a 10-pin connector, P2 is a 6-pin header, and P3 is a 4-pin header.

The  IS200WETBH1BAA has a single transformer component.  The board has over thirty relays of two different types.  There are fuses (10,) jumpers (2,) heat sinks (7,) voltage regulators (9,) coil inductors, TP test points, and a single switch components.  The board also has over fifty integrated circuits. The board uses varistors and high voltage electrolytic capacitors. Some resistors are made of metal film.  Installation procedures for the IS200WETBH1BAA may be found using user guides, data sheets, or manuals. Please follow all safety recommendations.

IS215WEMAH1BA

lf you need to inquire or purchase ,please send the product models to my email or call medirectly .

sunny  He

[Email] sales@xiongbagk.cn

[Mobile] 86-18059884797

[WhatsApp] 86-18059884797

[Skype] sales@saulcontrol.com

IS200WETBH1BAA Mark VI printed circuit board

There are three different software frame rates that are supported, which are in the range of ten to forty milliseconds. The frame rates indicate the amount of time elapsed between conditioning and reading the inputs, as well as sending the outputs, and executing the application software. If wishing to change the application software it will be done through five levels of password protection and can be downloaded to the control module while the main process is running.

Some of the main components of the IS215WEPAH2BB board are the female plug connectors. These plug connectors are located around the edge of the board and range from two to twenty pins. In the lower right-hand corner of the board, there is a daughterboard. There are also four metal oxide varistors, three of which are close together on the lower left-hand side of the board. The singular metal oxide varistor is located in the upper right-hand corner of the board.

The typical mounting location for the IS215WEPAH2BB board is in a VME rack with thirteen or twenty-one slots. The VME rack will then be located in the Control Module. Along with this model, the control module will have a variety of I/O cards, plus the main processor card. This board will typically only take up one slot of the VME rack.

Related products