MVME761-001 Transition Module MOTOROLA

Description

Overview

Essential details：MVME761-001 Transition Module MOTOROLA

Introduction
This manual provides general information, hardware preparation, installation instructions, and a functional description for the MVME761-001 and MVME761-011 Transition Modules.
Product Overview
The MVME761-0x1 Transition Module provides the interface between the MVME260x, MVME270x, MVME360x, or MVME460x Single Board Computer VMEmodule and various peripheral devices. This module provides industry standard connectors to simplify customer cable requirements for the serial port, printer, and Ethernet signals.
Features
The features of the MVME761-0x1 Transition Module include:
❏ Industry-standard connectors for these interfaces:
– Two EIA-574 asynchronous serial ports (DTE)
– Two asynchronous/synchronous serial ports, which can be configured for EIA-232-D, EIA-530, V.35, or X.21 interfaces (DCE or DTE)
– One parallel port (IEEE Standard 1284-I compliant)
– 10Base-T/100Base-TX Ethernet
❏ Two 60-pin Serial Interface Module (SIM) connectors for configuring the asynchronous/synchronous serial ports
❏ Single-width board
❏ Electro-Magnetic Interference (EMI) and Electro-Static Discharge (ESD) protection

MVME761-001

You may configure the asynchronous/synchronous serial ports (ports 3 and 4) to the appropriate interface by installing a Serial Interface Module (SIM). A SIM is a small “plug-in” printed circuit board that converts the TTL-level synchronous or asynchronous port signals to industry standard voltage levels used by the ports. The SIM contains the receiver and transmitter circuits for converting the input and output signals of the host
VMEmodule to the appropriate serial data communication protocol.
The SIMs for the MVME761-0x1 are listed in the following table.

The P2 adapters route the asynchronous and synchronous port, printer port, and Ethernet signals to the MVME761 transition module.
Three-row P2 adapter (MVME761-001)
The P2 adapter for the MVME761-001 mounts onto a 3-row, 96-pin P2 backplane connector. The 50-pin male connector, J2, carries the 8-bit SCSI signals from the MVME260x, MVME270x, MVME360x, or MVME460x. To run SCSI devices, you may install an additional transition module that is equipped with a SCSI port, such as the MVME712B.

lf you need to inquire or purchase ,please send the product models to my email or call medirectly .

Shipping

Superiority products MVME761-001 Transition Module MOTOROLA